Page
64
NOTE: Read through the following steps and decide
whether you want your amplifier to
sit
level, or whether you
wish the front of the chassis elevated. Then select the feet
and mounting hardware so the parts will be immediately
available
as
you install the cabinet. The screws for the
mounting feet will be inserted through the four holes in the
cabinet bottom and screwed into the captive nuts in the
flange of the chassis.
Refer to Pictorial
4-20
(fold-out from Page
56)
for the
following steps.
(
1
Place
a
book on a flat surface and balance the
amplifier chassis on the book, front panel uppermost.
(
Lower the cabinet onto the chassis
so
the captive nuts
in the chassis bottom flange are aligned with the four
holes in the cabinet.
Perform only
one
of the following
two
steps, depending
upon how you wish the amplifier cabinet positioned.
(
)
If you wish to have the amplifier cabinet
sit
level,
install a rubber foot at each corner of the cabinet. Use
6-32
x
1 1
11
6"
screws.
(
)
If you wish the front of the cabinet to be elevated,
install a rubber foot on each rear corner with
6-32
x
11/16"
screws. Then, install
a
tapered spacer and a
rubber foot
at
each front corner of the cabinet with
6-32
x
1-1 12"
screws.
NOTE: The blue and white identification label shows the
Model Number of your kit. Refer to these numbers in any
communications with the Heath Company.
(
1
Install the identification label in the following manner.
1.
Select
a
location for the label where
it
can easily be
seen when needed, but will not show when the unit
is
in operation, such as on the rear panel
(see
the
inset drawing in Pictorial
4-20).
2.
Carefully peel away the backing paper. Then
press
the label into position. You will avoid smearing the
numbers on the label if you will put the piece of
waxed backing paper on top
of
the label and then
rub on
it
instead of directly on the label.
This completes the assembly of your Linear Amplifier.
Proceed to "Installation."
To Next Page
Loading...
