Heathkit TA-16 - Page 13

Page 11
BOTTOM
OF CHASSIS
2-56 NUT
‘ f2-56.1/4 - SCREW
DIODE
MOUNTING CLIP
3 LOCKWASHER
Detail 6D
( • ) Similarly, mount the TA2577A/417-101
transistor, mica insulator and transistor
socket at Q10.
(/)'' Refer to Detail 6D, and mount the diode
mounting clip at K. Use a 2-56 x 1/4"
screw, a #3 lockwasher, and a 2-56 nut.
7
) ( Install circuit breakers at C and X as shown
in Detail 6E. Twist the mounting tabs to
hold the circuit breakers in place.
( /) Refer to Detail 6F, and mount the AC socket
at B. Push the socket in until the locking tabs
spread out and hold the socket in place.
Refer to Detail 6G, and install a 3-lug ter-
minal strip at H. Use 6-32 x3/8" hardware,
with one #6 lockwasher under and one above
the mounting foot. Position the terminal
strip as shown in the Pictorial.
( } Similarly, install a 5-lug terminal strip at
G.
OUTSIDE OF
CHASSIS APRON
Detail 6E
Detail 6F
LOCKING TAB
ff ii §) 6-32 NUT
6 LOCKWASHER
6 LOCKWASHER
4 16-32x3/8" SCREW
Detail 6G