Heatmiser neo Stat-e - Factory Reset; Setting the Switching Times

3231
Series
Setting the Switching Times
To program the switching times, follow these steps.
• Use the Left / Right keys to scroll to EDIT and press Tick .................................
• Use the Left / Right keys to select day/period of the week .............................
• Press Tick to conrm selection ...................................................................................
• 1 will now ash and the current ON time will be displayed.
The OFF time can be viewed by pressing the Down key ................................
• Select a switching time and press the Tick key ....................................................
• Use the Up / Down keys to select the ON time HOURS and press Tick .......
• Use the Up / Down keys to select the ON time MINUTES ................................
• Press Tick to conrm selection ..................................................................................
• Use the Up / Down keys to select the OFF time HOURS and press Tick .....
• Use the Up / Down keys to select the OFF time MINUTES ..............................
• Press Tick to conrm selection ..................................................................................
• Press the Right arrow key ............................................................................................
• 2 will now ash and the current ON time will be displayed.
• Repeat the steps above to set all periods. For any unused periods enter -- : --
• When complete, use the Left / Right keys to scroll to DONE and press
Tick to conrm all changes ........................................................................................
Factory Reset
To reset the device to factory default settings, follow these steps:
• Use the Left / Right keys to scroll to SETUP ...........................................................
• Press and hold the Tick key for 10 seconds ...........................................................
• All of the icons on the display will appear for 2 seconds, then the display
will show option 1 or 2.
• Use the Left / Right keys to scroll between modes (selection will ash) ....
Mode 1 = Thermostat
Mode 2 = Time Clock
• Press the Tick key to conrm selection ....................................................................
The thermostat will revert to the main display screen for the selected mode.
Note: Factory reset will cancel all parameters that were entered during the set-up and
pairing operations. These processes must be repeated after factory reset is completed.