Heatmiser neo Stat-e - Setting the Clock; Temperature Display

1413
Series
This neoStat-e can be congured for dierent sensor options such as built in air sensor,
oor sensor or both. The display will clearly indicate which sensor is being used by
showing either “Room Temp” or “Floor Temp” before the actual temperature value.
When the neoStat-e is set to use both the air & the oor sensor, the room temperature
will be displayed by default.
To view the current oor temperature, press and hold the Left and Right arrow keys
for 5 seconds, the oor temperature will then be displayed. .......................................
Setting the Clock
To set the clock, follow these steps.
• Use the Left / Right keys to scroll to CLOCK ........................................................
• Press Tick to conrm selection ...........................................................................................
• Use the Up / Down keys to set the hours (24 hour format) ............................
• Press Tick to conrm selection ...........................................................................................
• Use Up / Down keys to set the minutes ................................................................
• Press Tick to conrm selection ...........................................................................................
• Use Left / Right keys to set the the day .................................................................
• Press Tick to conrm selection and return to the main display ...........................
Temperature Display
Day
Minutes
Room Temperature Floor Temperature
Hours