27 / 40
PL
SK
DE
EN
CS
HU
• When an electric shock is caused, it is necessary more than anywhere else to put emphasis
on safety and risk elimination for the rescuers. The affected person usually stays in contact
with electrical equipment (source of injury) because of muscle spasms caused by the electric
shock. Traumatic process continues in this case. It is therefore necessary to TURN THE
POWER OFF FIRST using any possible way. Subsequently CALL AN AMBULANCE or other
professional service, and then PROVIDE FIRST AID! Ensure free airways, check breathing,
check pulse, put the affected flat on their back, bend their head and stick out their lower
jaw. If necessary, begin with artificial respiration into the lungs and heart massage.
UNPACKING
• Carefully check all parts after unpacking the product from the box.
• Do not throw away packaging materials until you have not reviewed carefully if they did not
remain a part of the product.
• Parts of the packaging (plastic bags, paper clips, etc.) do not leave within reach of children,
could be a possible source of danger. There is a danger of swallowing or suffocating!
• After unpacking, inspect the product thoroughly to make sure it wasn't damaged
during shipping and check that the packaging is complete. If you find any problems,
DO NOT USE THE PRODUCT and contact your dealer immediately.
• We recommend save the package for future use. The packaging materials must still be
recycled or disposed of in compliance with the relevant legislation. Sort different parts of
the packaging according to material and hand it to the appropriate collection sites. For
further information contact your local administration.
PACKAGE CONTENTS
bottom tube with angle drive gear, safety guard, additional safety guard, metal cutting disc,
trimmer head
C BATTERY and CHARGER are not included.
Poznámka: I
This product requires assembly. The device must be assembled correctly before
use.
• Standard accessories are subject to change without notice.
ASSEMBLY AND COMMISSIONING
CAUTION! A
Never run the unit without the proper equipment attached.
ASSEMBLY OF THE HANDLE
1. Loosen four allen screws on the handle holder on the upper tube shaft (fig. 2).
2. Insert handle into the holder on the tube shaft and fasten it by four screws (fig. 3).
3. Take care that gas cable get not twisted tight or broken.
To Next Page
Loading...