39 / 56
PL
SK
DE
EN
CS
HU
1. Throttle lever push to Slow position.
2. Having finished the work let the engine run for few minutes.
3. Switch turn to OFF position.
4. Turn the fuel valve - if equipped - to “0“ position.
5. Disconnect and ground the spark plug wire, to prevent accidental starting while equipment
is unattended.
6. In case of long operation break (after season) is recommended to mix additive to fuel as
a prevention of fuel deterioration and problems with restarting in the beginning of next
season. Do not use the fuel which is older that 14 days.
DRIVE GEARS
C Shift the gears only when the coupling is switched off (machine stands still) and
only with the engine switched on).
Change gears by means of gear lever (fig. 21A).
- Forward: 1 – slow, 3 – quick / Neutral - N / Reverse: R1
OPERATING
• Engage the required gear and slowly squeeze the clutch control lever. If the gear does not
engage straight away, slowly release the clutch lever and try again. In this way the powered
wheelbarrow will start moving.
• The powered wheelbarrow has the steering levers on the handlebars and this makes steering
very easy. To turn right or left, simply operate the corresponding right or left steering lever.
• The sensitivity of the steering increases in proportion to the speed of the machine and that
with the empty machine, a light pressure on the ever is all that is needed to turn. While
when the machine is loaded, more pressure is required.
• The maximum capacity of the transporter is listed in the Specifications. However, it is
advisable to assess the load and adjust it according to the ground on which the machine
will be used.
• It is therefore advisable to cover such stretches using low gear and taking extra care. In such
situations, the machine should be kept m low gear for the whole stretch.
• Avoid sharp turns and frequent changes of direction while driving on the road, in particularly
on rough, hard terrains full of sharp, uneven points with a high degree of friction.
• Remember to be careful when working in adverse weather conditions (ice. heavy rain and
snow) or on types of ground that could make the powered wheelbarrow unstable.
• When the clutch control lever is released, the machine will stop and brake automatically
• If the machine is stopped on a steep slope, a wedge should be placed against one of
the wheels.
BOWDEN CABLE ADJUSTMENTS
Adjusting clutch
• As clutch wears out. the same lever could have a wider opening, being so uneasy to use.
This means that it is necessary to adjust the cable, setting clutch lever on its original position
acting on the adjustment device and on counter-nut.
Adjusting steering
• If you have difficulty steering the unit, you will need to adjust the steering levers with
the special adjusters. Slacken off the locknut and unscrew the adjusters to eliminate the play
in the cable, which can occur after initial use or normal wear. Be very careful not to unscrew
To Next Page
Loading...
