hecht 2650 - Fuel System; Storage; Engine Adjustments; Storage Preparation

45 / 56
PL
SK
DE
EN
CS
HU
FUEL SYSTEM
CAUTION! A Spare parts of fuel system (plugs, hoses, tanks, filters etc.) must be
the same as original otherwise arises danger of fire.
• Regularly check the condition of fuel hoses.
• Replace the fuel hose every 2 years. If fuel leaks from fuel hose, replace the fuel hose
immediately.
ENGINE ADJUSTMENTS
CAUTION! A Do not change in any way the rated speed of the engine (carburetor
side or regulator side).
Your engine was adjusted in the factory. If the motor settings is changed in any way, the warranty
will be cancelled. If additional adjustment is necessary (eg. for high altitude), contact authorized
service center!
STORAGE
CAUTION! A Store this machine on place where the fuel vapors can not be in
reach of open fire or sparks. Let the fuel to run dry before long storage. Always let
the machine get cool before storing.
• Store the machine in a dry, clean and frost-protected place, out of reach of unauthorized
persons.
• Cover unit with a suitable protective cover that does not retain moisture. Do not use sheet
plastic as a dust cover. A nonporous cover will trap moisture around the machine, promoting
rust and corrosion.
• Replace worn or damaged parts for safety. Use only original spare parts.
• If the fuel tank has to be drained, this should be done outdoors.
STORAGE PREPARATION
Proper storage preparation is essential for keeping your engine trouble free and looking good.
The following steps will help to keep rust and corrosion from impairing your engine‘s function
and appearance, and will make the engine easier to start when you use it again.
CLEAN THE MACHINE BEFORE STORING ACCORDING TO THE PARAGRAPH MAINTENANCE
/ CLEANING
STORAGE PRECAUTIONS
• If your engine will be stored with gasoline in the fuel tank and carburetor, it is important
to reduce the hazard of gasoline vapor ignition. Select a well-ventilated storage area away
from any appliance that operates with a flame, such as a furnace, water heater, or clothes
dryer.
• Also avoid any area with a spark producing electric motor, or where power tools are operated.
• If possible, avoid storage areas with high humidity, because that promotes rust and corrosion.