hecht 2650 - Working in the Slope; Care and Maintenance

40 / 56
PL
SK
DE
EN
CS
HU
the adjusters too much because this can create another problem: the loss of traction.
Remember to tighten the locknut when you have finished.
WORKING IN THE SLOPE
Danger of injury by overturning machine. Work always slowly and pay high attention. Lead
the machine always up and down, never work horizontally or sideways in the slope. The machine
could lose balance and overturn. The machine must not be operated in slopes over 20%. Avoid
overturning machine – danger of fatal injury.
CARE AND MAINTENANCE
CAUTION! A To ensure proper functioning of the machine, it is necessary to have it
checked and adjusted by qualified personnel in an authorized service centre at least
once a year.
Good maintenance is essential for safe, economical and trouble-free operation.
Failure to properly follow maintenance instructions and precautions can cause you to be seriously
hurt or killed. Always follow the procedures and precautions in this owner‘s manual.
CAUTION! A Always allow the machine to cool down before maintenance.
WARNING! B If the machine is stopped for maintenance, inspection, storage or if
you need replace the accessories, switch off the engine, disconnect the spark plug
(unplug the electrical machine from the mains supply) and make sure that all moving
parts have completely stopped. If the machine is equipped with a key, remove it. Let
the machine get cool before any inspection, adjustment, etc.
• Keep this recommendation about checks, maintenance and intervals stated in this users
guide.
• Refer to the instructions for maintenance schedule, routine inspection procedures and
simple maintenance procedures using basic hand tools.
• The maintenance schedule is valid under normal operating conditions. If you operate
your engine under severe conditions, such as permanent high load, high temperature or
unusually large humidity or dust, contact your service on the recommendations applicable
to your individual needs and the way of using the machine in your case.
• Others service operations, which are more complicated, or it needs special tools, let it on
our authorized service..
• After the end of season, clean the machine carefully and grease or lubricate all the metal and
moving parts using Vaseline to have the machine ready for next season. Carefully inspect all
machine components before further deployment of the machine.
• Frequently check the proper tightening of screws, etc., in order to ensure safe operating
conditions of the machine.
• In case of abnormal vibrations proceed according to instructions (see instruction for removal
of fault).