30 / 56
PL
SK
DE
EN
CS
HU
Note: I
From the perspective of the law, this machine is a special vehicle unauthorised for
traffic. Consequently, it should NOT be used on roads other than in complete roadblock of
traffic operation.
SAFETY INSTRUCTIONS
• Know your tool. Read owner’s manual carefully. Learn its applications and
limitations as well as the specific potential hazards related to this tool. Familiarise
yourself with the controls on the machine and how to use them.
• Be careful at work, be concentrated on actual work, and use the common sense.
• An inattention during work may result in loss of control over the machine.
• Do not use this machine if you tired, ill or under the influence of alcohol, drugs or medication.
• Keep bystanders, helpers, pets, and children at least 10m from the machine while it is
operation. Stop the machine if someone enters.
• Do not put hands and feet near rotating parts or in the feeding chambers and discharge
opening.
• Do not overreach. Keep proper footing and balance at all times. This enables better control
of the tool in unexpected situations.
• Remove any adjusting key or wrench before turning the machine on. A wrench or a key that
is left attached to a rotating part of the machine may result in personal injury.
• Use safety equipment. Always wear eye protection. Safety equipment such as a dust mask,
non-skid safety shoes, hard hat, or hearing protection used for appropriate conditions will
reduce personal injuries.
• Dress properly. Do not wear loose clothing or jewellery. Keep your hair, clothing and gloves
away from moving parts. Loose clothes, jewellery or long hair can be caught in moving
parts.
• Prolonged use of the machine may lead to disorders of blood circulation in hands caused by
vibration. These effects can be worsened by low ambient temperatures and/or by gripping
the handgrips excessively tightly. Period of use you can extend with appropriate gloves or
regular breaks. Take frequent work breaks. Limit the amount of exposure per day.
DEVICE-SPECIFIC SAFETY INSTRUCTIONS
• Inspect the unit before use. Ensure the parts are installed correctly and secure.
• Never use the machine for transport of persons. Never stand on dump box.
• Do not work with equipment that is damaged, incomplete, or has been modified without
the authorisation of the manufacturer. Do not use the equipment with damaged safety
devices or screens or with missing safety equipment.
• Do not leave the equipment unattended in the workplace.
• Never leave the operating position when the engine is running.
• Start the engine carefully according to instructions and with feet well away from moving
parts.
• Always hold the unit with both hands when operating. Keep a firm grip on the handlebars. Be
aware that the machine may unexpectedly bounce upward or jump forward if the machine
should strike buried obstacles such as large stones.
• On soft ground, drive at the first forward/reverse gear. Do not rapidly accelerate, turn
sharply or stop.
• Pay the utmost attention when working on frozen ground as the machine may tend to skid.
• When tipping the load from a dumper, the center of gravity will change continuously and
the ground conditions will be essential for the stability of the machine. There are special
To Next Page
Loading...
