33 / 148
PL
SK
EN
CS
HU
WARNING!B
Prior to any work on the machine (maintenance, inspection, replacement of
accessories, servicing) or before storing it, ALWAYS SWITCH THE ENGINE OFF, wait
for all moving parts to stop and allow the machine to cool down. Prevent the engine
from being started accidentally. Disconnect the spark plug. If the machine is equipped
with a trigger key, remove it.
THIS WARNING IS NOT REPEATED IN ANY FOLLOWING POINTS!
Keep this recommendation about checks, maintenance and intervals stated in this users guide. Others
service operations, which are more complicated, or it needs special tools, let it on our authorized service.
The instructions in this manual apply under normal operating conditions. If you operate
your engine under severe conditions, such as permanent high load, high temperature
or unusually large humidity or dust, contact your service on the recommendations
applicable to your individual needs and the way of using the machine in your case.
MACHINE MAINTENANCE
• Keep the machine in good condition.
• Careful handling and regular cleaning ensure that the machine remains functional and
efficient for a long time.
• In case of abnormal vibrations proceed according to instructions (see instruction for removal
of fault).
• Keep all nuts, bolts and screws tight to be sure the equipment is in safe working condition.
• Always ensure that the ventilation openings are kept clear of debris.
• Replace worn or damaged parts for safety. Use only original spare parts.
• Replace safety and instruction stickers and labels with new if necessary.
• Always be careful when adjusting the machine to avoid jamming fingers between moving
blades and rigid machine parts.
• Regularly check the blade for damage.
CLEANING
CAUTION!A
Do not hose engine. Water can damage engine or contaminate the fuel system.
• If the engine has been running, allow it to cool for at least half an hour before cleaning.
• Clean the mower thoroughly from grass and dirt after each mowing.
• Clean under deck by tilting the machine so that the spark plug is always up.
• Wipe the surface of the machine and engine cover with dry cloth. Clean the cover of
the machine, especially the ventilation holes.
• Do not let the handles contaminate with oil or grease. Clean the handle clean with a damp
cloth washed in soapy water.
• Do not use solvents or petrol! This can cause irreparable damage to the product. The plastic
parts can be eaten away by chemicals.
• If any of the parts of the machine is cleaned by water or a damp cloth, etc., it must be
completely dry. Then the metal parts must be grease against the corrosion with suitable
protective oil. Make sure that the water doesn´t leak into the internal parts of the machine.
To Next Page
Loading...
