33 / 48
PL
SK
DE
EN
CS
HU
2. The depth limiter can be adjusted by sliding up or down as needed.
3. Align groove in depth regulator rod with the holes in bracket lock block and replace
the cotter pin (pic. 7) (23).
Do not adjust tilling depth unless tine clutch control lever is released to the neutral position.
TILLING
Tilling is digging in, turning over and breaking up garden soil and prepare a seedbed for planting.
A tiller will also clear the soil of unwanted vegetation. The decomposition of this vegetation
matter enriches the soil.
C If the soil is too stiff, it must be prearranged before cultivation (moistened or loosen)
to avoid damage of the plough shares or other parts of tiller.
Also, tilling soil that is too wet will produce unsatisfactory clods. Wait a day or two after heavy.
Rrain for the soil to dry.
C Do not use the machine in a case of heavy, wet clay soil. It can cause permanent
damage to the machine.
Better growth will be obtained if an area is tilled properly and used soon after tilling to preserve.
the moisture content. The type of soil and working conditions will determine the actual setting of
the tilling depth. In some soils, the desired depth is reached first pass over garden. In other soils,
the desired depth is obtained by going over the garden two or three times. In later case, the depth
regulator rod should be lowered before each succeeding pass over the garden. Passes should be
made across the length and width of the garden alternately. Do not try to dig too deeply in the irst
pass. If the machine jumps or bucks, allow the unit to move forward at a lightly faster rate. If the tiller
stops forward motion and tries to dig in one spot, rock the handles from side to side to start it
moving forward again. Rocks which are turned up should be removed from the garden area.
CARE AND MAINTENANCE
CAUTION! A
To ensure proper functioning of the machine, it is necessary to have it checked and
adjusted by qualified personnel in an authorized service centre at least once a year.
Proper maintenance is essential for safe, economic and trouble-free operation of
the machine.
Failure to follow the maintenance instructions and safety precautions may cause serious injury
or death. Always follow the procedures, safety precautions, recommended maintenance and
recommended checks mentioned in this manual.
WARNING! B
Prior to any work on the machine (maintenance, inspection, replacement of
accessories, servicing) or before storing it, ALWAYS SWITCH THE ENGINE OFF, wait
To Next Page
Loading...
