hecht 785 - Mounting Accessories and Wheels

26 / 48
PL
SK
DE
EN
CS
HU
7. Fix the rubber grips on the handlebars (Fig. 4b). To fix it properly we recommend to use
a suitable adhesive to grips (you can buy in stores with bicycle or motorcycle accessories)
8. Mount the throttle lever to the machine handle using the screw - on the right handle from
view of the operator. (Fig. 5).
9. Using fixing screws to attach lower handle to the cultivator (Fig. 6).
10. Install upper handle with control elements using plastic screws with nuts (Fig. 7).
11. Attach the depth regulator to the cultivator and thread the safety pin into the holes and all
secure with cotter pin (Fig. 8).
12. Install the plough in next step, so that it is plugged into the cultivator shaft and insert with
safety pins and secure with cotter pins (Fig. 9).
13. Attach the fenders with three screws on each side of the cultivator (Fig. 10).
CAUTION! A
Always mount the same number and type of accessories on the machine shaft
(wheels, blades).
CAUTION! A
When installing the plughshare pay attention to correct direction of rotation.
Pluhgshares are not symmetrical, they can not be freely exchanged left - right.
Therefore the ploughshares must be mounted in right direction (Fig. 9.).
ASSEMBLY OF ACCESSORIES AND AUXILIARI
WHEELS
If the soil is too stiff, it must be prearranged before cultivation (moistened or loosen)
to avoid damage of the plough shares or other parts of tiller.
Use the hiller, potatoe digger or plough only for a prearranged soil. The soil should be free of
stones and solid objects, it can not be flattened.
CAUTION! A
Do not use the machine or accessories in a case of heavy, wet clay soil. It can cause
permanent damage to the machine.
ASSEMBLY OF ACCESSORIES
Note: I
For mounting accessories like plows, hiller or potato digger is necessary to use
the bracket – adapter HECHT 8001002.
1. Mounting the plough holder (or other accessory)
2. Remove the rear pin lock and the pin (Fig. 8).
3. Remove the rear spur.
4. Slide the holder into place with the spurs, with the upper recess on the upper pin. Secure
the holder with two bolts at the bottom (Fig. 12).