30 / 48
PL
SK
DE
EN
CS
HU
CAUTION! A
Be sure to take care of any problem you find, or have authorized service dealer to
correct it, before you operate the engine. Improper maintenance to this engine, or
failure to correct a problem before operation, can cause malfunction in which you
can be seriously hurt or killed.
HIGHER ALTITUDES
• The engines operating at high altitudes (above 1600 meters above sea level) require the special
attention, because decrease of the fuel mixture saturation ratio to supersaturation. This
leads to the power loss and higher fuel consumption. For more information, contact an
authorized service center.
OPERATION
The instructions in this manual apply under normal operating conditions. If you operate
your engine under severe conditions, such as permanent high load, high temperature
or unusually large humidity or dust, contact your service on the recommendations
applicable to your individual needs and the way of using the machine in your case.
THE CULTIVATOR IS INTENDED FOR LOAD WHEN MOVING FORWARD ONLY.
PLYNOVÁ PÁKA
0
= OFF (vypnuté) = rýchlo (prac. otáčky)
= pomaly (voľnobeh) = sýtič (studený štart)
TO START ENGINE
1. Ignition is connected through the cable and the spark plug cap (the rubber boot) with
the spark plug. Check the connection.
2. Open the fuel valve ,,1” (Fig. 20 A)
3. Adjust the choke lever (Fig. 20 B) into the position START ,,1” (choke turned on) when cold
engine, into the position RUN ,,0” (choke turned off) when warm engine.
4. Move the engine speed control lever from the minimum position to about 1/3 (Fig. 21).
5. Adjust the switch on/off (Fig. 22) into the position ON.
6. Grasp the starter handle (Fig. 23) and pull gently on the starter handle until it begins to
resist, then pull quickly and forcefully upwards.
C Do not allow the starter grip to snap back against the engine. Return it gently to
prevent damage to the starter.
7. After 3-5 clouds, the engine start. After starting the engine, move the choke off ,,0“ and
move throttle lever into position
.
8. Push the safety switch and simultaneously push the clutch lever (Fig. 1-1), the work tool
begins to move immediately.
To Next Page
Loading...
