HEIDENHAIN TNC 151 Q - Page 50

Function
The “scaling” cycle can apply
to 2 or 3 axes
.Programmed stop with MO6
.Output of M89
.no axis standstill if - with
a TOOL CALL - spindle rpm
is output only
.no axis standstill with output
of an M-function
Switchover HEIDENHAIN-
dialogue programming /
IS0 (G-code)-programming
.Projection of display graphics
.Coordinate system rotation in
the working plane
Parameter
No.
213
214
217
236
Possible
entry values
0 A
=
The programmed
scaling factor is
effective in the 3
main axes X, Y, ,Z
1 *
=
The programmed
scaling factor is
effective in the
working plane
0 *
=
Programmed stop
with M06, M89 normal
output at beginning
of block
1 n
zz
No programmed stop
with M06, M89 normal
output at beginning
of block
2 2
Programmed stop with
M06, M89 modal cycle
call at block end
3 4
IT
No programmed stop
with M06, M89 modal
cycle call at block end
.
+4-
if 4 is added to the
previous entry value,
no axis standstill
occurs with output
of spindle rpm.
. +8-
if 8 is added to the
previous entry value,
no axis standstill
occurs with output
of an M-function.
Exception: Axis standstill occurs
with M-functions which are
followed by a programmed stop
(such as MOO, MO2 . .) or a
STOP or CYCL CALL-block
0 4
=
HEIDENHAIN-dialogue
1 r\
=
IS0 (G-code)-format
0 A
=
German standard
1 A
=
US-third angle
projection
2 - if 2 is added to the
previous entry value,
the coordinate system
is rotated bv + 90’.
Selected
entry values
50