HEIDENHAIN Programming Station TNC 320/TNC 620/TNC 640 11
1.2 Compatibility
1.2 Compatibility
The programming modes provide the same features as a TNC 320,
TNC 620 or TNC 640 connected to a machine tool (NC software: see
"TNC model, software and features", page 3). You create programs:
in HEIDENHAIN conversational format or according to ISO,
with graphic support during programming and for program
verification,
and with all other proven TNC features, such as FK free contour
programming.
You work with the original TNC software—without any compatibility
problems. Part programs created with the programming station run on
any machine tool equipped with the appropriate control and NC
software (see "TNC model, software and features", page 3). A
requirement for this to work is that the programming station software
must have been interfaced to the machine and that the software
options you are using must have been enabled on your machine.
If you also use the programming station to create programs
for older software versions or older TNC contouring
controls, please note the section below on Downward
compatibility.
To Next Page
Loading...
