HEIDENHAIN Programming Station TNC 320/TNC 620/TNC 640 55
2.2 Connecting the programming station
Configuring the programming station software
for use with a USB network dongle
All computers to which you want to give access to a network dongle
must be configured in the following way:
Start the programming station software
Double-click the green HEIDENHAIN symbol to the lower right in
the taskbar for the TNC Control Panel to appear (see figure)
Click the More >> button: Additional settings are displayed
Click the Settings button: Programming station settings are
displayed
Select the Use Hardlock Server option
In the Server input field, enter the IP address or the network name
of the computer which you are using as a server, i.e. the computer
to which you have connected the USB network dongle
Press OK to confirm your settings
Changes do not take effect until you restart the
programming station software: Press the Restart TNC
button.
You do not need to install any additional drivers on the
client PC to be able to access the USB network dongle.
To Next Page
Loading...
