40
1.4 Data transfer from the programming station to the machine tool
Calling a program from the machine tool
Select the Programming and Editing operating mode
Call the file manager: Press the PGM MGT key
Select the target directory to which you want to copy the program
created with the programming station
Select the split-screen view
In the right-hand window, select the <c:\pgmtransfer> directory on
the programming station PC
Select the program to be transferred, and transfer it to the machine
tool
Connection between the programming station
and HEIDENHAIN PC software
To be able to set up a connection between HEIDENHAIN PC software
(e.g. TNCremo or CycleDesign) and the programming station, the
programming station has a special IP address, the so-called loop-back
IP. Use the local (TCP/IP localhost) type of connection or enter the
loop-back IP 127.0.0.1 in the corresponding configuration menu of the
HEIDENHAIN PC software. Then you can set up a connection with the
programming station as if you were connected with a machine.
Refer to the TNC User's Manual for more information about
copying files.
To Next Page
Loading...
