54
2.2 Connecting the programming station
Installing the programming station software
Place the programming station CD in the CD-ROM drive
The CD browser starts automatically if your CD-ROM drive has been
appropriately configured. If Autostart is not active, run the
<Start.exe> file
Choose the language to be used for the CD navigation
Select <Install software>
Select <Install TNC programming station> in order to start the
installation program
Follow the installation program instructions
Note that all files are overwritten during installation of an
update.
If you have created files or made any changes to files, make
backup copies of these before installation.
You can install this programming station version on your PC
together with another version (e.g. iTNC 530) already
installed on your PC. However, it is not possible to use the
applications simultaneously. If a programming station is
active, close it before starting another programming
station.
To Next Page
Loading...
