HEIDENHAIN TNC 640 - Differences in Other Functions

HEIDENHAIN Programming Station TNC 320/TNC 620/TNC 640 33
1.2 Compatibility
Differences in other functions
Other functions of the iTNC 530, TNC 426/TNC 430, TNC 310 and
TNC 410 controls
Meaning of the symbols used in the table:
x Function not available in this software version
þ Function available in this software version
Function iTNC 530
TNC 426/
TNC 430
TNC 310 TNC 410
340490 280476 286140 286060
CYCL CALL PAT þþxx
CYCL CALL POS þ xxx
Cutting data tables (WMAT block) þþxx
Feed rate F in the CHF block þþþþ
Contour definition DECLARE CONTOUR þ xxx
Tilting the working plane: PLANE þ xxx
Positioning behavior of rotary axes TCPM FUNCTION þ xxx
FK programming: FL P2X/FLT P2X þþxx
FK programming: FL P2Y/FLT P2Y þþxx
FK programming: FL RX/FLT RX þþxx
FK programming: FL RY/FLT RY þþxx
FK programming: FL RPR/FLT RPR þþxx
FK programming: FL RPA/FLT RPA þþxx
FK programming: FL RAN þþxx
FK programming: FC LEN/FCT LEN þþxx
FK programming: FC AN/FCT AN þþxx
FK programming: FC P2X/FCT P2X þþxx
FK programming: FC P2Y/FCT P2Y þþxx
FK programming: FC P3X/FCT P3X þþxx
FK programming: FC P3X/FCT P3Y þþxx
FK programming: FC RX/FCT RX þþxx
FK programming: FC RY/FCT RY þþxx
FK programming: FC RPR/FCT RPR þþxx