34
1.2 Compatibility
Other functions of NCK-based TNC 320, TNC 620 and TNC 640
controls
Meaning of the symbols used in the table:
FK programming: FC RPA/FCT RPA þþxx
FK programming: FC RAN/FCT RAN þþxx
FK programming: FC RCCX/FCT RCCX þþxx
FK programming: FC RCCY/FCT RCCY þþxx
FK programming: FC RCCPR/FCT RCCPR þþxx
FK programming: FC RCCPA/FCT RCCPA þþxx
Function iTNC 530
TNC 426/
TNC 430
TNC 310 TNC 410
340490 280476 286140 286060
x Function not available in this software version
þ Function available in this software version
Function TNC 320 TNC 620 TNC 640
340551 340560 340590
CYCL CALL PAT þþþ
CYCL CALL POS þþþ
Cutting data tables (WMAT block) x x x
Feed rate F in the CHF block þþþ
Contour definition DECLARE CONTOUR þþþ
Tilting the working plane: PLANE þþþ
Positioning behavior of rotary axes TCPM FUNCTION x þþ
FK programming: FL P2X/FLT P2X þþþ
FK programming: FL P2Y/FLT P2Y þþþ
FK programming: FL RX/FLT RX þþþ
FK programming: FL RY/FLT RY þþþ
FK programming: FL RPR/FLT RPR þþþ
FK programming: FL RPA/FLT RPA þþþ
FK programming: FL RAN þþþ
FK programming: FC LEN/FCT LEN þþþ
FK programming: FC AN/FCT AN þþþ
FK programming: FC P2X/FCT P2X þþþ
To Next Page
Loading...
