HEIDENHAIN TNC 640 - Page 44

44
1.5 Special features of the demo version
Select the smarT.NC mode (not for
TNC 320, TNC 620 and TNC 640)
Select the Handwheel operating
mode
Select the Positioning with MDI
operating mode
Select the Program Run, Single Block
operating mode
Select the Program Run, Full
Sequence operating mode
Select the Programming and Editing
operating mode.
Select the Test Run operating mode
Define touch probe cycles
Define fixed cycles
Call fixed cycles
Define subprograms and program
section repeats
Call subprograms and program
section repeats
Enter a program stop
Define tool in the program
Call the tool
Call the soft-key menu for special
functions
Enter program call
TNC function TNC key PC key
3
§
2
"
Q
W
E
4
$
R
A
S
D
F
G
Y
X
C
V
B