Heiniger Opal - Changing the Battery; Changing the Clipperhead

Translation of the original instructions / Small animal clipper 15
6.2.2 Changing the battery
When the battery is unloaded, the clipper is turned off by a protective circuit.
1 2
1. Movetheswitchtoposition"0"(g.4).
2. Pushthebatteryinterlock(2)onboth
sides inward and pull the battery (1)
out of the clipper.
Fig. 20
1 2
3. Insert charged battery (1) into the
shearer (2), until the battery lock is
lockedinonbothsides.
Fig. 21
6.2.3 Changing the clipperhead
1. Movetheswitchtoposition"0"(g.4).
2. Pushtheinterlockclipperhead.
Fig. 22
3. Fold the clipperhead ahead when
theinterlockclipperheadispressed.
4. Takeofftheclipperhead.
5. Clean the opened hinge by the help
of the provided brush.
Fig. 23
6. Fit the favoured clipperhead to the blade hinge and fold it on to the swit-
ched-onclipperbylightpressure.(g.17,18,19).
NOTE!
Onlyworkwithsharpblades,replacebluntordefectivebladeswithoutteeth.
The correct resharpening of blades is only to do by special machines or by a
specialist. In that case, contact your service centre.