Heiniger Opal - Lubrication; Cleaning

16 Translation of the original instructions / Small animal clipper
6.2.4 Lubrication
To receive good clipping results and to increase the durability of the clipper
and the clipperhead, it is necessary to apply a thin oil coat between top and
bottomblade(g.24).
CAUTION!
Unsufcientlubricationoftheclipperheadcausesheatingandareduced
durability of clipper and blades, as well as a reduction of the battery runtime.
Therefore:
X
Lubricate the blades sufciently during the clipping (at least every 15
minutes),sothattheydonotdrain(g.24).
X
Only use the lubricants prescribed by the manufacturer.
NOTE!
Onlyuseourspecialoiloraparafnoil
meetingtheISOVG15specication.
The provided oil is non-toxic and produces no irritation on contact with the
skinorthemucousmembranes.Thisparafnoildegradestosome20%
after 21 days (CEL-L-33-T-82).
Fig. 24
The blades must be oiled before, during
and after every use. When the blades
of the clipper are leaving stripes, this is
a signal that oil is required. Place a few
drops of oil ahead and laterally on the
clipperblades(seearrowsing.24).
Wipe off the excessive oil with a smooth,
dry cloth. Lubrication sprays do not have
sufcient oil for agood lubrication, but
serve for cooling the blades. Immediate-
ly change damaged or crenated blades
toavoidinjuries.
CAUTION!
Removealltheleaking,useduporexcessivegreasefromallthelubrication
points, and it is to be disposed in accordance with the local regulations.
6.2.5 Cleaning
To receive good clipping results and to increase the durability of the clipper
and the clipperhead, it is necessary to apply a thin oil coat between top and
bottom blade (6.2.4 Lubrication).
Clipperhead and hinge
Clean clipperheads und hinge between the different clippings.