Henny Penny EVOLUTION ELITE EEE-182 - 5-3. Clock Set; 5-4. Advanced Diagnostic Modes

Model EEE-182
5-11
5-3. CLOCK SET
1. Press and hold the button for 5 seconds until “LEVEL
2”, followed by, “SP PROG” and “ENTER CODE” show in
the display.
2. Press the button again and “CLK SET” and “ENTER
 CODE”ashintheleftdisplay.
3. Entercode1,2,3(rst3productbuttons). 
4. “CS-1ENTERDATEMM-DD-YY”ashesintheleft
display. Use the product buttons to set the date in the right
display.
5. Pressbuttonand“CS-2ENTERTIME”ashesinthe
 leftdisplayandthetimeashesintherightdisplay.Press
the or , or use product buttons, to change the time.
6. Pressbuttonand“CS-2ENTERTIME”ashesinthe
 leftdisplayand“AM”or“PM”ashesintherightdisplay.
Use the or buttons to choose AM or PM.
7. Pressbuttonand“CS-3TIMEFORMAT”ashesin
the left display and “12-HR” or “24-HR” shows in the right
display. Use the or buttons to choose a 12 hour
time format or a 24 hour time format.
8. Press button and “CS-4 DAYLIGHT SAVING TIME”
 ashesintheleftdisplay.Usethe orbuttons
to choose daylight saving time for your area: 1.OFF; 2.US
(2007 & after); 3.EURO; or 4.FSA (US before 2007).
The Data Logging, Heat Control, Tech, Stat and Filter Control
Modes are advanced diagnostic and program modes, mainly for
Henny Penny use only. For more information on these modes,
contact the Service Department at 1-800-417- 8405 or 1-937-
456-8405.
5-4. DATA LOGGING, HEAT
CONTROL, TECH, STAT,
AND FILTER CONTROL
MODES
July 2016