Model EEE-182
1-3
Problem Cause Correction
POWER switch ON
but fryer completely
inoperative
• Open circuit • Plug fryer in
• Check breaker or fuse at supply
box
• (Non-US/some Int’l. locations
only)
Breakers in fryer tripped-open
left door and reset breaker on
fryer; See below
Oil will not heat but lights
are on
• All power cords not
plugged-in
• Unit has 2 power cords; make
sure both are plugged-in
Control error code “E-10” • Open high limit circuit • Let unit cool down (15-20
minutes), reset the high limit
switch on the inside of the
LH door; if high limit does
not reset, high limit must be
replaced.
Vatisunder-lled • JIB is low or empty
• JIB oil line is clogged or
collapsed
• Filter pan needs cleaned
• Fill the JIB
• Check JIB line
• Cleanlterpanandchange
paper or pad
July 2016
To Next Page
Loading...
