27
(1) i3s switch
1
(2) i3s indicator
2
•
The i3s indicator (2) will glow on the meter
console for 2 seconds and turn “OFF”. For
the activation of i3s system, start the engine
and let it idle till the engine gets warmed up
(Engine oil temperature read by ECU shall
be more than 75°C).
• If engine is stopped by any means other
than i3s function, i3s indicator lamp will not
glow/blink in the meter console after
engine stop. In this condition, vehicle will
not start by brake & slight throttle. Vehicle
can be started by using kick or electric start.
Initial activation of the i3s system:
• Put the vehicle in stand still condition on its
main stand (Speedometer pointer is on 0
km/h).
Ensure that the r/min should not cross
2000.
• Keep the i3s switch (1) to “ON” position.
• Turn the ignition key to “ON” ( ) position.
• The i3s indicator (2) on the meter console
will glow for 2 seconds and turns “OFF”.
• Start the engine and allow it to run at idle
r/min.
After 500 seconds, i3s indicator will be
“OFF” and the vehicle can only be started
by using kick or brake & electric starter.
• The i3s indicator will be continuously “ON”
for 11 seconds before engine cuts-off by
i3s system (Engine oil temperature read by
ECU shall be more than 75°C). After
engine cuts-off by i3s, i3s indicator will
blink for 500 seconds, waiting user input to
start engine by pressing brake & slight
throttle, brake & electric start or kick.
During this 500 seconds interval, if the
vehicle is pushed at speed greater than or
equal to 5 km/h, vehicle can be started by
applying slight throttle only.
To Next Page
Loading...
