28
NOTE
After 500 seconds, i3s indicator will be
“OFF” and the vehicle can only be started by
using kick or brake & electric starter.
•
If for the first time vehicle is started and rider
crosses 20 km/h speed. After that, vehicle
is kept in idle (Engine r/min less than 2200
r/min), vehicle is in stationery condition
(Speedometer pointer is on 0 km/h), Engine
is warmed up (Engine oil temperature read
by ECU shall be more than 75°C) then the
engine will be turned “OFF” in 11 seconds.
•
The i3s indicator will be continuously “ON”
for 11 seconds before engine cuts-off by i3s
system (Engine oil temperature read by ECU
shall be more than 75°C). After engine cut-
off by i3s, i3s indicator will blink for 500
seconds, waiting user input to start engine by
pressing brake & slight throttle, brake &
electric start or kick. During this 500
seconds interval, if the vehicle is pushed at
speed greater than or equal to 5 km/h,
vehicle can be started by applying slight
throttle only.
• If engine is stopped by any means other than
i3s function, i3s indicator lamp will not
glow/blink in the meter console after engine
stop. In this condition, vehicle will not start
by brake & slight throttle. Vehicle can only
be started by using kick or self start.
• If i3s switch is put on “OFF” position once
the engine is stopped by the i3s system then
vehicle can only be started by using kick or
brake & electric starter.
Driving with i3s switch in “ON” position:
If the engine is stopped by i3s and it remains
in “OFF” condition for more than 500
seconds then vehicle can only be started with
brake & electric starter switch or kick.
While driving in very dense traffic where the
vehicle has to encounter a stop and go
situation, the i3s switch can be put to “OFF”
position. Once this is done, the i3s system will
not work and the vehicle will be in normal
operating conditions as other vehicles and no
special functions will be performed.
Driving with i3s switch in “OFF”
position:
NOTE
•
The i3s system will not function if rider puts
the i3s switch to “OFF” position.
• If the vehicle is driven without battery or
with the dead battery and the engine r/min
is less than 2200. The i3s indicator on the
speedometer will blink continuously at every
1.5 secs. The rider can start vehicle by using
kick.
• If the low battery voltage is detected while
the ignition key is in “ON” position or engine
is in running condition, the i3s function will
be deactivated until the rider turns the
ignition switch to “OFF” ( ) position and
then back to “ON” ( ) position. The rider
can start vehicle by using kick.
• If the battery voltage is low and engine
r/min is less than 2200, there will be 3
continuos blinks after every 6 secs.
To Next Page
Loading...
