•
To end the adjustment press the mode
button (3) until clock display stops blinking.
(b) Odometer/Tripmeter
The odometer (1) shows accumulated
distance travelled.
The tripmeter (2) shows distance travelled
since trip meter was reset last time. There are
two tripmeters, “Trip-1” and “Trip-2”.
Push the mode button (3) to select “Trip-1”
and “Trip-2”. “Trip-1” and “Trip-2” can be
displayed upto " km.999.9"
If the tripmeter exceeds "999.9" km it will
return to "0.0" km automatically.
•
The time advances fast when the button is
pressed and held.
When tripmeter is selected, long press (more
than 2 seconds) the set button to reset
tripmeter to zero. The odometer can be
displayed from "0 to 99999" km.
Trip meter displays following parameters:
•
Distance: distance covered in a trip.
•
Avg Speed: average speed at which vehicle
completes a trip
•
Trip time: time taken to complete a trip.
•
Date: it shows the current date.
To update the date proceed as follows :
•
Turn the ignition switch "ON" ( ).
•
Press and hold set button (4) and mode
button (3) simultaneously for more than 2
seconds. The clock display will start blinking
(page 17).
NOTE
NOTE
•
The clock will reset to if the battery “1:00”
is disconnected.
•
If mode or set buttons are not operated for
30 seconds or more, the setting will be
invalid and return to the normal operation.
When ignition switch is turned “OFF”, the
value immediately before “OFF” shall be
set.
(1) Odometer (2) Tripmeter
(3) Mode button (4) Set button
(5) Date
5
4
241.6 km
Avg
45.1 km/h
Time
1h 06m
Trip 1
1
30 Aug
3
2
(3) Mode button
14:48
14:41
3
16
241.6 km
Avg
45.1 km/h
Time
1h 06m
Trip 1
30 Aug
F
FF
E
EE
km/h
x 000
I
RPM
Gear
ODO
ODOODO
km
0
00
I
II
2
22
3
33
4
44
5
55
6
66
7
77
8
88
9
99
IO
IOIO
II
IIII
x 000
I
F
F
F
E
E
E
km/h
RPM
Gear
ODO
ODO
ODO
km
0
0
0
I
I
I
2
2
2
3
3
3
4
4
4
5
5
5
6
6
6
7
7
7
8
8
8
9
9
9
IO
IO
IO
II
II
II
241.6 km
Avg
45.1 km/h
Time
1h 06m
Trip 1
30 Aug
To Next Page
Loading...
