71
WARNING
!!
An improperly adjust headlamp may blind
oncoming rider/driver or it may fail to light the
road for a safe distance.
CATALYTIC CONVERTER
This vehicle is equipped with the catalytic
converter in the muffler to meet the emission
norms.
The catalytic converter contains precious
metals that serve as catalysts, promoting
chemical reactions to convert the exhaust
gasses without affecting the metals. The
catalytic converter acts on HC, CO and NOx.
The catalytic converter must operate at a high
temperature for the chemical reactions to take
place. It can set on fire any combustible
material that come near it. Park your vehicle
away from high grasses, dry leaves, or other
flammable material.
A defective catalytic converter contributes to
air pollution and can impair your engine’s
performance.
Follow these guidelines to protect your
vehicle’s catalytic converter.
• Always use unleaded petrol. Even a small
amount of leaded petrol can contaminate
the catalyst metals, making the catalytic
converter ineffective.
• Keep the engine in good running condition.
A poorly running engine can cause the
catalytic converter to overheat.
•
Turn the adjusting nut (2) to position stop
lamp switch at a point where the stop lamp
will glow just before the brake pedal is
depressed to the limit of its free play. Turn
the adjusting nut in direction (A) to advance
switch timing or in direction (B) to retard
switch timing.
HEADLAMP FOCUS ADJUSTMENT
Headlamp is factory preset. However in case
of adjustment required, please follow the steps
as given below:
•
Headlamp adjustment is done by the
headlamp adjusting bolt (1) located below
headlamp.
•
Park the vehicle on level ground.
•
Turn the ignition switch to “ON” ( )
position and start the engine.
•
ampAdjust the headl beam vertically
by the loosening bolt & move the headlamp
unit forward & backward for correct focus
adjustment.
(1) Headlamp adjusting bolt
1
To Next Page
Loading...
