62
CAUTION
!!
Do not operate front brake lever when the
wheel is removed.
(1) Axle nut (2) Axle (3) Wheel
(4) Left & right side collars
4
TORQUE : 5.2 kgf-m
• After installing the wheel apply the brake
several times and then check if the wheel
rotates freely. Recheck the wheel if the
brake drags or if the wheel does not rotate
freely.
(1) Side collars
1
Installation
•
Install the left & right side collars (1) to both
sides of the wheel hub.
•
Position the front wheel between the fork
legs and align the disc between the brake
pads to avoid damage to the pads. Insert the
axle from the right side through the fork legs
and wheel hub.
•
Tighten the front axle nut to the specified
torque.
(b) Front wheel ( )Drum variant
Removal
• Support the vehicle securely on the main
stand and raise the front wheel off the
ground.
• Disconnect the front brake cable (1) and
integrated brake cable (2) from the
integrated brake arm (3) and brake panel
(4) by removing the front brake adjusting
nut (5) and integrated brake adjusting nut
(6).
3
1
1
2
To Next Page
Loading...
