33
To connect a mobile phone charger, first
remove the cap from the USB charger and
then plug in the charger cable to it.
Use of non-standard USB cable may cause
damage to the mobile phones.
Hero MotoCorp will not be responsible for
damages caused due to use of non standard
USB cable.
• Always place the device in a soft clean
cloth/towel to avoid any damage due to
road shocks while riding.
• This port is for charging compatible USB
devices.
• Multiple charging of USB devices have to be
avoided, simultaneous charging may lead to
slow or no charging.
• Do not leave the USB device and USB cable
in the fuel tank cover when the vehicle is
parked.
• Charge your device only when the engine is
operational/while riding. Charging the USB
device when the engine is “OFF” would lead
to early discharge of battery.
CAUTION
!!
• Do not apply any soap solution, oil or grease
inside the USB charger.
• Any personal belongings have to be removed
before water washing to avoid damage.
• Always keep the USB port cap closed after
use to prevent dust or water entry during
rains/water wash.
NOTE
• Do not direct water jet towards the port even
with cap closed to avoid any short circuit.
Always dry the area using a dry cloth or
moisture free compressed air before use.
PRE-RIDE INSPECTION
You should conduct pre-ride inspection
before riding the vehicle to enhance riding
comfort and safety. Clean your vehicle
regularly. It protects the surface finish. Avoid
cleaning with products that are not specifically
designed for vehicle surfaces. Inspect your
vehicle very day before you start the engine.
The items listed here will only take a few
minutes, and in the long run they can save
time, expense and possibly your life. Please
follow the tips as given below:
• Engine oil level- Check and top up engine
oil if required (page 45). Check for leaks.
• Programmed FI malfunction indicator
lamp (MIL)- When the ignition switch is
turned “ON” the programmed FI
malfunction indicator lamp(MIL) glows
continuously and then should go “OFF”
once the engine is started.
• Fuel level- Ensure sufficient fuel is
available in your fuel tank for journey. Fuel
level segment should be above one segment
blinking (page 18). Check for leaks.
• Front brake (Disc type)- Check for
correct brake fluid level in the master
cylinder (page 56).
To Next Page
Loading...
