18
(c) Fuel gauge
The fuel gauge (1) indicates approximate fuel
available in the form of digital segments.
The digital segments (2) will swing to
maximum scale on the meter console once the
ignition switch is turned “ON” ( ). If all the
segments are displayed it means fuel quantity
in the fuel tank is 10 litres.
If only one segment (3) is displayed and
blinks, this indicates the fuel quantity is low
and the fuel tank should be refilled as soon as
possible.
Please ensure the vehicle is not used
continuously when the fuel level indicator
reaches the one segment blinking. It will not only
result in the vehicle running out of fuel, it may
also cause serious damage to the fuel pump.
Please ensure fuel is filled up as soon as the fuel
level indicator reaches one segment blinking.
CAUTION
!!
NOTE
To check the fuel level indication, the vehicle
should be on levelled surface and in stationary
condition.
2
3
(d) Real time mileage indicator (RTMI)
The real time mileage indicator (RTMI) (1)
shows the current mileage of the vehicle in
km/litre and is refreshed after every 3
seconds. Press the mode button (2) until
RTMI is displayed.
When the ignition switch is turned “ON” ( )
position, the real time mileage indicator will
temporarily show the digit “0.0” km/litre
The display range is from (km/litre).
(1) Real time mileage indicator (RTMI)
(2) Mode button
2
The fuel consumption shall be displayed when
the speed of the vehicle is 5±2 km/hr. If the
speed is less then 5±2 km/hr “0.0”
km/litre will be displayed.
1
S
SS
1
(1) Fuel gauge (2) Segments
(3) One segment
To Next Page
Loading...
