EasyManua.ls Logo

HERO GLAMOUR XTEC PROGRAMMED FI - i3 s (Idle Stop Start) System; i3 s System Operation and Driving Modes

HERO GLAMOUR XTEC PROGRAMMED FI
90 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
28
Initial activation of the i3s system:
Keep the i3s switch (1) to “ON” position.
Turn the ignition key to “ON” position. The
i3s indicator (2) on the speedometer console
will glow for 2 seconds and turn “OFF”. Start
the vehicle (in neutral and clutch lever released
condition) with less than 2000 r/min and let
it idle till engine temperature reaches more
than 75°C. The engine will cut-off in 30
seconds. After the first stop start, every
subsequent stop will be in 5 seconds.
In this condition, the engine can be restarted
either with clutch lever, kick or electric start.
Driving with i3s switch in “ON” position:
While driving, if the engine is kept idling (while
waiting in a traffic signal), the engine will cuts-
off in 5 seconds. (The vehicle should be in
stand still condition, with neutral gear position
at less than 2000 r/min with clutch
lever/throttle is in released position and
Driving with i3s switch in “OFF” position:
While driving in a traffic jam/or very dense
traffic where the vehicle has to encounter a
stop and go situation, the i3s switch can be
changed to “OFF” position. Once this is done,
the i3s system will not work and the vehicle
will be in normal operating conditions as other
vehicles and no special functions will be
performed.
engine is warmed up The i3s indicator will ).
be continuously blinking in the speedometer
indicating that vehicle stopped in i3s
condition. By pressing the clutch lever, the
engine will start again and gear can be
engaged to move the vehicle.
NOTE
If vehicle stops in i3s condition and kept idle
for more than 500 secs (ignition switch is
ON position) i3s function will be
deactivated and cannot be started by
pressing the clutch lever, rider can only start
the vehicle with electric or kick start.
If engine is stopped by any means other than
i3s function, i3s indicator will not
glow/blink in the speedometer. In this
condition, vehicle will not start by pressing
the clutch lever. Vehicle can be started by
using kick or electric start.
If all the required i3s conditions are met, i3s
indicator will glow for 5 secs before the
engine cuts-off.
(2) i3s indicator
2

Related product manuals