35
NOTE
If MIL remains “ON” even if the vehicle is
started, there is an abnormality in the
programmed FI system. It is recommended to
reduce the speed and drive to the Authorised
Hero MotoCorp workshop for check-up.
Ÿ Find neutral position & check neutral
N indicator (3) on instrument console
with ignition “ON”.
(1) Ignition switch (2) Programmed FI
malfunction indicator lamp (MIL)
2
1
Preparation
Before starting insert the key and follow the
below mentioned procedure :
•
Turn the ignition switch (1) to “ON” ( )
position.
•
Confirm that the programmed FI
malfunction indicator lamp (MIL) (2)
glows continuously and then should go
“OFF” once the engine is started.
(3) Neutral indicator
3
(4) i3s switch
•
Make sure whether the i3s switch (4) is in
“ON” or “OFF” position.
• Electric start : Press the electric starter
switch with fully closed throttle.
• Kick start : Depress the kick starter until
resistance is felt. Then let the kick starter
return to the top of its stroke. Kick from the
top of the stroke through to the bottom with
a rapid, continuous motion.
4
To Next Page
Loading...
