26
Maintenance schedule
Perform the Pre-ride Inspection (page 20) at each scheduled maintenance period.
I: INSPECT C: CLEAN R: REPLACE A: ADJUST L: LUBRICATE T: TOP UP
To be serviced by your Authorised Distributor/Dealer unless the owner has the
relevant tools, technical information and is technically qualified.
Ensure that each paid service is availed within 90 days or 3000 km from the date of previous
service, whichever is earlier.
Note-3 : Replace engine oil once in every 6000 km. Top up if the oil level is at or near the
lower level mark
Note-8 : Inspect for any play in the mounting bushes, replace if necessary.
Note-4 : Visit Authorised Distributor/Dealer for inspection, cleaning, lubrication and
adjustment of drive chain at every 2000 km.
In the interest of safety, we recommend that these jobs are carried out only by your
Authorised Distributor/Dealer.
Note: Always wipe the water from the vehicle after washing. Use clean soft cloth or pressurized
air for completely drying the water.
Note-2 : Replace air cleaner element once in every 15000 km or early replacement may
be required when riding in dusty areas.
Note-5 : Replace once in every two years or 30000 km, whichever is earlier.
Note-9 : Check idle CO emission along with idle rpm/idle CO adjustment (if required).
Note-7 : Inspect the wheel bearings free play, replace if necessary.
Note-6 : Inspect & maintain specified torque.
The following Maintenance Schedule specifies all maintenance required to keep your vehicle in
peak operating condition. Maintenance work should be performed in accordance with
standards and specifications of by properly trained and equipped HMCL Niloy Bangladesh Ltd.
technicians. Your Authorised Distributor/Dealer meets all of these requirements.
Note-10 : Inspect the canister hoses for deterioration, damage or loose connections and
canister for cracks or other damages.
O: OIL CHANGE E: EMISSION CHECK
Note-1 : At higher odometer readings, repeat the frequency interval established here.
To Next Page
Loading...
