62
•
While refilling the oil make sure that no
foreign material enters the final drive
transmission.
•
Make sure that no oil gets on the tyre or
wheel.
At transmission disassembly: 0.12 Litre
• Install the oil level check bolt with a new
sealing washer and tighten it.
SPARK PLUG
Refer to the safety precautions (page 54).
•
Disconnect the noise suppressor cap (1)
from the spark plug.
Champion-RG8YC (Federal Mogul)
•
Clean any dirt around the spark plug base.
Recommended spark plug.
•
Remove the center cover (page 35).
• Inspect the electrodes and center
porcelain for deposits, erosion or carbon.
• Remove the spark plug using the
wrench plug provided in the tool kit.
(1) Noise suppressor cap
1
0.8-0.9 mm
(2) Side electrode
2
•
The spark plug must be securely tightened.
An improperly tightened plug can become
very hot and possibly damage the engine.
•
Never use a spark plug with an improper
heat range. Severe engine damage could
result.
•
Tighten a new spark plug 1/2 turn with a
wrench plug to compress the washer. If you
are reusing a plug, it should only take 1/8-
1/4 turn after the plug seats.
•
With the plug washer attached, thread the
spark plug in by hand to prevent cross
threading.
•
Reinstall the noise suppressor cap.
fouling. If the erosion or deposit is heavy,
replace the plug. Clean carbon or wet
fouled plug with a plug cleaner.
• Check the spark plug gap using a wire-type
feeler gauge. If adjustment is necessary,
bend the side electrode (2) carefully.
To Next Page
Loading...
