HERO Passion Xpro - Page 48

45
CW- Clockwise, ACW- Anticlockwise
ü
X
3
(A) Cut-out not seated (B) Cut-out seated
3
4
4
(3) Adjusting nut (4) Brake joint pin
(A) Decrease free play (B) Increase free play
•
Apply the brake several times and check for
free wheel rotation when released.
NOTE
If proper adjustment cannot be obtained by
this method, visit your Authorised Hero
MotoCorp workshop.
•
Make sure that the cut-out on the adjusting
nut is seated on the brake joint pin (4) after
the final adjustment has been made.
(g) Brake wear indicators
(Drum type)
When the brake is applied, an arrow (1), fixed
to the brake arm (2), moves towards a
reference mark (3) on the brake panel (4). If
the arrow aligns with the reference mark on
full application of the brake, the brake shoes
must be replaced.
(1) Arrow (2) Brake arm
(3) Reference mark (4) Brake panel
3
2
1
4
Front brake wear indication
Rear brake wear indication
(1) Arrow (2) Brake arm
(3) Reference mark (4) Brake panel
4
3
2
1