Betriebsanleitung_firestar_18-40_Lambda_Englisch_V1.6 3
TABLE OF CONTENT
1 Safety notes ................................... 4
1.1 Warning notes ...................................... 5
1.2 Installation ............................................ 5
1.3 Operation and maintenance ................ 6
1.3.1 General notes ......................................... 6
1.3.2 Operation ................................................ 6
1.3.3 Maintenance ........................................... 6
2 Fuels............................................... 7
2.1 Suitable fuels ........................................ 7
2.2 Not suitable fuels ................................. 7
3 Starting up a cold system ............. 8
4 Handling of the heating system ... 9
4.1 Sealing the boiler ................................. 9
4.2 Operation with low performance
decrease ................................................ 9
4.3 Overheating of the boiler ..................... 9
4.4 Sweating of the boiler .......................... 9
4.5 Taking out of operation ....................... 9
5 Boiler operation ........................... 10
5.1 Preparation for heating up ................ 10
5.2 Heating up ........................................... 10
5.3 Energy absorption capacity / STL .... 11
5.4 Re-heating ........................................... 13
6 Maintenance and cleaning .......... 13
6.1 De-ashing and cleaning general ....... 13
6.2 Cleaning of the heat recovery areas
(manual) .............................................. 13
6.3 Cleaning of the combustion chamber14
6.4 Cleaning the flue pipe ........................ 15
6.5 Filling shaft – Filling shaft door ........ 15
6.6 Checking the heat exchanger ........... 15
6.7 Checking the water level for the
heating unit ......................................... 15
6.8 Keeping the boiler room clean .......... 15
7 Fault-free operation ..................... 15
8 Boiler status ................................ 16
8.1 Unit off ................................................. 16
8.2 Burning phase .................................... 16
8.3 High running phase ............................ 16
8.4 Control phase ..................................... 16
8.5 Ready ................................................... 16
8.6 New start-up ........................................ 16
8.7 Re-heating ........................................... 16
8.8 Chimney sweeper ............................... 16
8.9 Lambda calibration (password
protected) ............................................ 17
8.9.1 Flue temperature control ...................... 17
8.9.2 Lambda control ..................................... 17
8.9.3 Control curve ........................................ 17
9 Description of the menu
navigation and adjustment values18
9.1 Main menu ........................................... 18
9.1.1 Structure ............................................... 18
9.1.2 Display .................................................. 18
9.1.3 Modify value ......................................... 18
9.1.4 Code entry (only Service) ..................... 19
9.2 Status menu (S) .................................. 20
9.3 Parameter menu (P) ............................ 22
9.4 Aggregate-Test Output (A) ................ 24
9.5 Aggregate-Test Input (E) .................... 25
10 Fault reports and their correction26
11 Emission measurement .............. 30
11.1 Measurement notes ............................ 30
11.2 Measurement preparation.................. 30
11.3 Establish measurement condition
(continous operating state) ............... 30
11.4 Measurement performance................ 30
12 EC-Declaration of conformity ..... 31
13 Index directory............................. 32
14 Notes ............................................ 33
To Next Page
Loading...
