Hesai PandarQT - 4.2 Settings - Trigger, Standby & Reset

28
(Continued on the next page)
(continued)
Trigger Method
Angle-Based / Time-Based
In the angle-based trigger mode, lasers fire
every 0.6 deg at 10 Hz.
In the time-based mode, lasers fire every
166.66 us.
Standby Mode
Whether to stop the motor from running and
lasers from firing
3. Reset All Settings
By clicking the “Reset All Settings” button on the top-right corner,
all configurable parameters in the Settings page and the Azimuth
FOV page will be reset to their default values.
The default values are shown in the left-hand screenshot and in
Section 4.3.1.