Heta GREEN200 - Manual Feeding; Time to Service; Screenlock

17
4.5.3 Manual feeding
Before turning on your heating device for the
first time (or in case you ran out of combu-
stible), the feeder screw may be completely
empty and due to this fact the first ignition may
fail. To avoid this unwanted situation, Heta
Premium display allows you to refill the feeder
screw before starting up the heating device.
To activate the manual feeding, follow the
steps below:
- Tap on and then on ”Manual feed” to enter
the Manual feed menu.
Activate the manual feeding by holding the
”FEED” icon. After holding the icon for 30
seconds, the manual feeding will be automati-
cally deactivated again. If 30 seconds were not
enough to refill the feeder, hold the icon again.
Repeat it untill the pellets starts to fall con-
stantly into the burning pot.
4.5.4 Time to service
The Heta Premium Display allows you to check
the time when you should contact the service
personnel to perform regular maintenance on
your combustion system.
To check the time to service, follow the steps
below:
- Tap on to enter the Settings menu.
- Tap on ”Time to service” and the time remai-
ning untill the service must be performed will
be shown on the screen. This value is read-only
and can be modified by authorised personnel
only. After checking the time to service, close
the window with
OK
or .
Note:
When the time to service expires, the Heta Pre-
mium Display warns you by displaying the A002
alert (Call service for regular maintenance). The
heating device is still operational. To reset this
alert, call authorised personnel.
4.5.5 Screenlock
The Heta Premium Display allows you to lock
the screen in order to prevent accidental chan-
ges of the settings. With the screen lock en-
abled, you can navigate the menu to display
current values, but you cannot edit any of the
settings, except the screen lock itself. Note that
this option does not disable the Heta remote
control.
The screen lock setting offers the following
options:
OFF
: The screen lock is disabled, all func-
tions are available.
LOW
: Impossible to change settings, only
possible to turn ON/OFF the heating device.
When this option is selected, the icon appe-
ars in upper row of the display.
HI
: all the functions are locked (also tur-
ning ON/OFF the heating device), only return
to LOW or OFF option is enabled). When this
option is selected, the icon appears in up-
per row of the display.
Note:
When the Screen lock function is set to LOW or
HI, all the disabled options are light grey
coloured.
Tip
We recommend you to use the screen lock op-
tion if children are able to access the keyboard
without adult supervision.
To use the screen lock function, follow the
steps below::
- Tap on and then on ”Screen lock” to enter
the Screen lock menu.
- Select the desired locking level (OFF, LO, HI)
and exit from the Screen lock menu by tapping
on .