4
Accompanying your pellet stove you will find:
a. Operating Guide
b. Cleaning brush
c. Power cable
d. Heta glove
e. Remote control
f. Data plate
g. Test chart
h. Two 80mm couplings
i. Set screws
j. Top cover
k. Cover when filling pellets
l. 3.15A fuse (sparepart)
m. Baffleplate
1. Introduction
NB !!!
We advise you to read these instructions care-
fully, as they describe what you need to do to
ensure your Greenfire pellet stove functions to
its full potential.
Warning
The regulations relating to installation and func-
tion described in these instructions may differ
from the applicable regulations in the destina-
tion country. If this is the case, the regulations
applicable in the destination must be observed.
Drawings in these instructions are approximate
and not to scale.
Description of the stove
The aim of these instructions for use and ser-
vicing from Heta is to give the user all the ne-
cessary safety information, in order to prevent
any personal injury or damage to stove com-
ponents or other items. Please read these in-
structions carefully before using or performing
maintenance on the appliance.
2. Information
The packaging used provides good protection
against damage that might arise during trans-
portation of the stove. Please check the stove
immediately upon delivery. If you notice any
visible signs of damage, contact your dealer
without delay.
2.1 Safety information
Please read these instructions regarding use
and maintenance carefully before installing and
lighting the stove! If you need further informa-
tion, please contact the dealer from whom you
purchased the stove.
NOTE
The stove has extra protection in line with po-
wer regulations, and must have an earthed
electrical connection.
Only quality pellets with a diameter of 6-8 mm
should be used as fuel.
Before connecting power to the stove, make
sure that the connection between the stove
pipe and chimney is in place.
Never remove the protective grate above the
pellet tank.
The stove must be installed in a room with ade-
quate air replacement.
Never open the stove door while the stove is
operating. When the stove is lit, the surfaces,
glass, handle and stove pipe will be very hot.
While the stove is operating, these components
may only be touched if wearing appropriate
protection.
2.2 General information
The Greenfire pellet stove must only be instal-
led in residential environments. The stove has
fully automatic control, ensuring controlled
combustion. The control system manages the
ignition process, five heat levels and shutdown,
ensuring that the stove functions correctly.
The design of the bowl used for combustion
ensures that most of the ash from the pellets
falls into an ash drawer. However, you should
check the burn pot each day, as not all pellets
are of equal quality.
Air flow is used to help keep the glass clean,
however it is impossible to avoid the glass be-
coming sullied after some usage.
Only pellets 6-8 mm in diameter should be
used as fuel in the Greenfire pellet stove.
To Next Page
Loading...
