USER MANUAL | NOVA OCUs
33
B.2 Safety Checklist
The following checklist provides general safety guidelines for radio control operation of equipment by fully qualified and tr ained
operators. These recommendations do not take precedence over any of the following requirements relating to cranes, hoists,
lifting devices or other equipment which use or include Hetronic products:
Instructions, manuals, and safety warnings of the manufacturers of the equipment where Hetronic products are
used,
Plant safety rules and procedures of the employers and the owners of the facilities where the Hetronic products
are being used,
Occupational Health and Safety Administration (OSHA) regulations,
Safety standards and practices for the industries in which Hetronic products are used.
OCU Start-up and Safety Checklist
1 Are batteries fully charged?
2 Are all switch decal symbols clear and legible?
3 Is the OCU enclosure free from cracks and other damage compromising
ingress protection?
4 Are the battery enclosures free from cracks and other damage?
5 Is the STOP function working as it should be?
6 Is the correct key cap being used?
7 Has each function of the OCU been tested independently
the equipment is responding correctly?
8 Is the TFT (where applicable) free from cracks and other damage
making it hard to read?
9 Are the switches/rubber caps free from damage/tear?
10 Are all LEDs on the OCU working and clearly visible?
11 Are the battery charger and power cord in good working condition?
12 Is the control cable (where applicable) free from kinks and other
damage?
13 Do you hear any rattling components inside the OCU? Consult your
supervisor if so and refrain from using the unit until it is serviced.
To Next Page
Loading...
