GLOBAL S - User Manual
Starting the Measuring Machine
Starting the measuring machine is one of the operations necessary to start the entire measuring system
(measuring machine, control system and measuring software).
Starting the Measuring Machine
1. Read carefully the section entitled “Safety Regulations and Residual Risks During Use” on page 30.
2. Open the shut-off valve of the pneumatic control unit and check that the pressure indicated on the
pressure gauge is the correct value.
3. Complete the measuring system startup procedure by following the instructions given in the user
manuals of the control system and measuring software.
The thermal compensation system only starts when the user activates it using
the appropriate functions of the software in use. The thermal compensation
systems compensates for the temperature of the machine axes and the
temperature of the part.
Stopping the Measuring Machine
Before stopping the measuring machine, check that the machine is not moving so as to avoid damage to
the machine, the parts being measured and the tools used.
Stopping the Measuring Machine
1. If possible, move the central carriage to the −Z position (at the bottom of its stroke).
2. Complete the measuring system shutdown procedure by following the instructions given in the user
manuals of the control system and the measuring software.
3. Close the shut-off valve of the pneumatic control unit to avoid wasting air and ensure optimum safety
conditions.
To Next Page
Loading...
