HEXING HXE310 - Page 33

User manual for poly-phase meter
27
Tamper Event
Terminal Cover Open
Terminal cover close
Magnetic Influence Detection start
Magnetic Influence Detection end
Meter Cover Open
Meter Cover close
Association authentication failure
(n time failed authentication)
Module Cover Open
Module cover close
Current reversal(any phase current reversal happen )
Relay Control Event
Manual disconnection
Manual connection
Remote disconnection
Remote connection
Local disconnection
Limiter threshold exceeded
Limiter threshold ok
Limiter threshold changed
Local reconnection
Disconnect/Reconnect failure
Power Quality Event
Power down (short power failure)
Power up (short power failure)
Low power factor start
Low power factor end
Frequency abnormal start
Frequency abnormal end
Power down(long power failure)
Power up(long power failure)
Phase Failure L1 start
Phase Failure L1 end
Phase Failure L2 start
Phase Failure L2 end
Phase Failure L3 start
Phase Failure L3 end
Missing voltage L1 start
Missing voltage L1 end