HID EDGE EVO EH400-K - Internal Optical Tamper; Relay Jumpers; Tamper Reader Interface Board; Door Interface Board Groups

INSTALLATION GUIDE
An ASSA ABLOY Group brand
EDGE EVO 82000-921, Rev. D.3
Page 11
B.2 Internal Optical Tamper
The Controller Optical Tamper can not be disabled. The Optical Tamper is suppressed by properly
installing the back plate which contains a post with white paint on it and securing it to the unit. To
disable the internal module optical tamper sensors:
• Right side of PCB (reader interface board): attach a jumper wire from P2 pin 10 to P2 pin 5.
• Left side PCB (door interface board): attach a jumper wire from P3 pin 1 to P3 pin 2.
CAUTION: The EH400-K ships from HID Global with these jumpers pre-installed on the connectors.
Removing these jumpers causes false tampers to trigger.
Note: If desiring an external tamper, wire an unsupervised Normally Closed contact, replacing one of
the pre-installed jumpers.
B.3 Relay Jumpers
AUX Wet
CAN V+
AUX Wet
+12VDC
AUX Dry
DS Wet
CAN V+
DS Wet
+12VDC
DS Dry
3 1
P9
P5
P8
3 13 1 3 1
P6
P4
P7
3 13 1
JUMPER =
B.4 Tamper (Reader Interface Board)
The Reader Tamper + and - are implemented allowing a connection for an open collector external
tamper from a reader, such as iCLASS.
Note: Connect P2, Pin 2 (GND) from the Reader Interface Board to the same ground as the reader
power if the reader is not powered by the unit's 12 VDC output port.
B.5 Door Interface Board Groups 1 and 2
Following are the inputs for Group 1 and Group 2 configurations.
Group 1 Group 2
Input Port Pin Input Port Pin
AC - P3 Pin3 Input 4 - P3 Pin3
AC + P3 Pin 4 Input 4 + P3 Pin 4
BATT - P3 Pin 5 Input 3 - P3 Pin 5
BATT + P3 Pin 6 Input 3 + P3 Pin 6
REX - P3 Pin 7 Input 2 - P3 Pin 7
REX + P3 Pin 8 Input 2 + P3 Pin 8
Door Mon - P3 Pin 9 Input 1 - P3 Pin 9
Door Mon + P3 Pin 10 Input 1 + P3 Pin 10