INSTALLATION GUIDE
An ASSA ABLOY Group brand
EDGE EVO 82000-921, Rev. D.3
Page 6
4 Install to Backplate
Contact EDGE EVO with the information provided in the next section.
5 Contact
Contact EDGE EVO through one of the following methods:
Direct Connect
If connecting EDGE EVO to a network using static IP addressing or if the Discovery GUI is not installed
on the PC, use this method.
Note: The computer must be running Windows 2000 or XP and be configured for DHCP.
1. Disconnect the computer from the network and directly connect EDGE EVO to the computer with
an Ethernet cable.
2. Select Start > Run and enter ipconfig /renew.
3. Open a web browser and enter 169.254.242.121 into the Address field.
Discovery GUI (for DHCP Networks)
With a DHCP network, use the HID Discovery GUI on the PC to locate and connect the Controller.
Note: The Controller must be connected to the network before power is applied for DHCP to function.
Java is required for the Discovery GUI.
1. With the PC connected to the same network as the Controller, double-click hid-discovery.exe.
Note: If the HID Discovery Application is not on the PC, download the application from
www.hidglobal.com/drivers. Search for “Discovery” and the DISCOVERY GUI download window
will appear.
2. Select the device from the list and click the Launch Browser button.
To Next Page
Loading...
