2.1 Introduction
This section describes the setup and installation for the HDP6600 card printer.
If you have a lamination unit to set up, see the HDP6600 Lamination Installation Guide (PLT-04395) that is included with
the lamination unit for information.
2.2 Selecting a good location
The following guidelines help to ensure optimal printing performance:
l
Place the unit in a location with adequate air circulation to prevent internal heat buildup.
l
Use the dimensions of the printer as a guideline for the minimum clearances to the unit.
l
Allow for adequate clearance in front of the unit to accommodate the unit with its covers open.
l
Do not install the unit near heat sources such as radiators or air ducts or in a place subject to direct sunlight,
excessive dust, mechanical vibration, or shock.
2.3 Moisture condensation
If the unit is brought directly from a cold to a warm location or is placed in a a very damp room, moisture may condense
inside the unit. Should this occur, print quality may not be optimal.
Leave the unit unplugged in a warm, dry room for several hours before using to allow any moisture to evaporate.
For safety purposes, Ethernet is not intended for a direct connection outside of the building.
Attention: Pour des raisons de sécurité, Ethernet n'est pas conçu pour une connexion directe à l'extérieur du
bâtiment.
2.4 Unpacking and inspection
While unpacking the printer, inspect the carton to ensure that damage did not occur during shipping.
Make sure that all supplied accessories are included with the unit:
l
US/EU power cable
l
Card input cartridge
l
Card output hopper
l
Ferrite
l
USB cable
Make sure you have these accessories that are supplied separately:
l
HDP film
l
Print ribbon
l
Cards
PLT-02931, A.4 17 November 2021
Powering
Trusted Identities
FARGO® HDP®6600 High Definition Card Printer/Encoder
User Guide
To Next Page
Loading...
