1.3 Safety messages-United States
Symbol Critical instructions for safety purposes
Danger Failure to follow these guidelines results in personal injury or death. To prevent personal injury or death, reference the
following safety messages before performing an operation:
l
Always remove the power cord prior to performing repair procedures, unless otherwise specified.
l
Ensure only qualified personnel perform these procedures.
ESD This device is electrostatically sensitive. Damage to the device may occur if it is exposed to static electricity discharges. To
prevent damage, reference the following safety messages before performing an operation:
l
Observe all established Electrostatic Discharge (ESD) procedures while handling cables in or near the circuit board and
printhead assemblies.
l
Always wear an appropriate personal grounding device.
l
Always remove the ribbon and cards from the printer before making any repairs, unless otherwise specified.
l
Remove jewelry and thoroughly clean hands before working on the printer.
Caution This symbol warns of an electrical hazard that could result in personal injury or death.
Caution For safety purposes, do not use Ethernet for a direct connection outside of the building.
Warning This symbol warns of a hot surface that could result in personal injury.
PLT-02931, A.4 9 November 2021
Powering
Trusted Identities
FARGO® HDP®6600 High Definition Card Printer/Encoder
User Guide
To Next Page
Loading...
