HID FARGO HDP 6600 - Page 46

Device Settings
Menu option Description
Left/Right
Lamination Type:The type of laminate affects the temperature required for lamination. Available options are:
l
Clear Whole PolyGuard™
l
Clear Whole UV Blocking PolyGuard
l
Holographic Orbit View PolyGuard
l
Holographic Whole PolyGuard
l
Clear Chip Cutout PolyGuard (left bay only)
l
Clear Chip Cutout UV Blocking PolyGuard (left bay only)
l
Holographic Chip Cutout PolyGuard (left bay only)
l
Clear Polyguard, Hafl Patch (right bay only)
l
Holographic PolyGuiard, Half Patch (right bay only)
Lamination Position:Click the arrows to adjust the horizontal position of the laminate. The default is 0. The
adjustment arrows point in the direction the patch moves on the card. The maximum horizontal value is 100
pixels (10 pixels=0.03" [0.8mm])
Lamination Temp offset: Available values are ±20.
Flatten Card
Enable: Select this option to enable the flattener.
Dwell Time (seconds per inch): Sets the Dwell Time for the flattening process.
l
Lower limit = 1 second per inch
l
Upper limit = 3 seconds per inch
Print Mode If Flip Card Before Printis selected, the reverse side of the card is printed first.
This option is available only for dual-sided card printing and is grayed out if a dual-sided module is not
detected.
PLT-02931, A.4 46 November 2021
Powering
Trusted Identities
FARGO® HDP®6600 High Definition Card Printer/Encoder
User Guide