Multi-spectrum Binocular User Manual
12
record video, or configure parameters on your phone.
Steps
1. Search the HIKMICRO Sight on App Store (iOS System) or Google Play™ (Android
System) to download it, or scan the QR code to download and install the app.
2. Press to show the menu.
3. Go to Advanced Settings, and press or to select .
4. Press to enter the setting interface.
5. Press or to select Hotspot. The hotspot function is enabled.
6. Turn on the WLAN of your phone and connect to the hotspot.
●
Hotspot Name: HIKMICRO_Serial No.
●
Hotspot Password: Serial No.
7. Open the app and connect your phone with the device. You can view the interface of
device on your phone.
Note
●
The device cannot connect to the app if you enter wrong password several times.
Refer to
Restore Device
to reset the device, and connect the app again.
●
The device should be activated for the first use. The default password must be
changed after the activation.
2.9 Firmware Status
2.9.1 Check Firmware Status
Steps
1. Open the HIKMICRO Sight and connect your device to the app.
2. Check if there is an upgrade prompt on the device management interface. If there is no
upgrade prompt, the firmware is the latest version. Otherwise, the firmware is not the
latest version.
To Next Page
Loading...
Need help?
General
